Threaded View
-
07-09-2022 #12
To check if the limits cables were broken or not I knew the problem was related to the Y and A axis limits because the problem happens only when I try to home these 2 axis. So I disconnected first the A axis limits cable at both ends and installed a temporary brand new cable. Then I try to home the Y axis and the same message comes up. Did the same for the Y axis and the results was the same. So the message “Limits switch triggered” is not related to broken cables.
If someone can answer my previous post about what the M4++Limits / M4Home message refers to I may understand more and perhaps be able to solve the problem
Thanks
Thread Information
Users Browsing this Thread
There are currently 16 users browsing this thread. (0 members and 16 guests)
Similar Threads
-
Sumtor Control Board - homing/limit switches
By Roy-J in forum Motor Drivers & ControllersReplies: 16Last Post: 26-05-2021, 08:29 PM -
High Precision Homing Switch
By Chaz in forum General ElectronicsReplies: 19Last Post: 17-04-2018, 05:34 PM -
One limit switch per axis
By EddyCurrent in forum General ElectronicsReplies: 17Last Post: 30-09-2013, 11:38 AM -
FOR SALE: Z axis with Home/limit switch and Nema 23 3nm
By Shinobiwan in forum Items For SaleReplies: 6Last Post: 02-02-2013, 10:54 AM -
Limit switch's - best configuration?
By HiltonSteve in forum General ElectronicsReplies: 16Last Post: 13-08-2009, 01:26 PM
Bookmarks