Diy concrete cnc

[masinecc]

It's already done for you inside the bags.
Pre-mixed, just have to add water

Lucky you. Pms share the name on the mix, i wanna see the technical data sheet and see what i can find close to it locally

[XYZ_Spec]

Lucky you. Pms share the name on the mix, i wanna see the technical data sheet and see what i can find close to it locally

Here it is the manufacturers site page for this product I've used.
It seems to be only available in Portuguese language.
This is the best I can do for you.

https://www.cimpor.com/-/betao-seco-be-30

[Lee Roberts]

Lucky you. Pms share the name on the mix, i wanna see the technical data sheet and see what i can find close to it locally

Same...

Here it is the manufacturers site page for this product I've used.
It seems to be only available in Portuguese language.
This is the best I can do for you.

https://www.cimpor.com/-/betao-seco-be-30

Thanks for sharing...

What about this probe, how you finding it, accuracy etc?

https://youtube.com/shortsNtOfxCaf4lU

P.S Is it still v6: 3D Touch Probe Edge Finder ???

[XYZ_Spec]

What about this probe, how you finding it, accuracy etc?

https://youtube.com/shortsNtOfxCaf4lU

P.S Is it still v6: 3D Touch Probe Edge Finder ???

Yes Lee, V6.
I like it a lot, and it's not crazy expensive.
I want to install it permanently onto the spindle mount, this will allow me to set zero without having to do a tool change.

[XYZ_Spec]

Hi guys,

One year after designing and 3D printing a prototype that failed because it wasn't water proof, finally machined the housing from aluminum.
I'm really happy with how it came out.
It was a really cool project.

Hope you enjoy it too.

[Lee Roberts]

Nice, what finish did you use paint or anodised?

[XYZ_Spec]

Nice, what finish did you use paint or anodised?

Spray paint.
One day will anodize all the aluminum parts.

[Lee Roberts]

Ok I thought so, keep an eye on the internal paint, the coolant *could* react with the paint and make it dissolve/flake off and block your spindle internal tubes, it should be ok I think but something to check later...

[XYZ_Spec]

I'll keep an eye on it. I was hesitating to paint the interior bore, but I thought if i didn't try I would not know

Thanks for your tip Lee

[XYZ_Spec]