Diy concrete cnc

**Lee Roberts** · 26-03-2023

Nice!, it will be interesting to find out if you run into any sensitivity issues when you run a probing command, I know someone who has done a similar setup but using a linear actuator rather than a motor, the stop/start forces as gentle as they are, cause his specific (similar style) probe to detect the movements as tip indications/false contacts with the part as the probe moves down ready to be used.

**XYZ_Spec** · 26-03-2023

Originally Posted by Lee Roberts

Nice!, it will be interesting to find out if you run into any sensitivity issues when you run a probing command, I know someone who has done a similar setup but using a linear actuator rather than a motor, the stop/start forces as gentle as they are, cause his specific (similar style) probe to detect the movements as tip indications/false contacts with the part as the probe moves down ready to be used.

Hi,
My probe only gets connected when it gets to the final position.
You can see that happening int these videos.