Threaded View
-
17-10-2022 #9
Thanks for that. The Dropbox links in many of the posts have vanished. That's the trouble with using free services.
Your concrete construction looks good. The SX2P is a lot smaller but suits me as my main interest is clockmaking after I discovered that three generations of my ancestors were clock and watchmakers and decided that I should revive the tradition. I think I'll get a TB6560 board to replace the current one and hope that it will see me out!
RussellLast edited by Lee Roberts; 17-10-2022 at 08:26 PM. Reason: Fixed quote
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
TB6600 4 axis board - GPIO input?
By kjames23 in forum Motor Drivers & ControllersReplies: 8Last Post: 21-04-2020, 11:31 AM -
Csmio-IPM wiring A nema 17 TB6600 driver Z axis THC
By Copypaste in forum CS-Lab (CSMIO)Replies: 0Last Post: 14-02-2019, 08:41 PM -
Looking for an CNC xPro controller board
By centurian in forum Spindles & Drive MotorsReplies: 21Last Post: 21-09-2018, 10:03 PM -
What controller, board or stand alone
By Silver in forum General DiscussionReplies: 6Last Post: 26-07-2018, 10:01 PM -
Question about sink/source on motor controller to bob
By Toolman321 in forum General ElectronicsReplies: 3Last Post: 22-09-2017, 06:24 PM
Bookmarks