Quote Originally Posted by lateAtNight View Post
Hey Smiler,
I just put in my order for one of DIY Cnc's BOBs, and I'm a little concerned that you're going with a different make. Was it a user error, or did it give up the ghost on its own? :D. Should I be thinking about canceling my order, and going with someone else?

I really like what you've done...

Dave.
User error Dave. My main BOB is a DIYCNC Uniport and I'm very pleased with it indeed. Buffered outputs for 4 drivers and three relays onboard that don't need external power. The original one was an Optoport which I shorted out trying to wire in a relay in my hamfisted way. Roy repaired it FOC and I put it back in as Port2 so I could have some extra inputs to Mach. Well, I managed to do the same trick and shorted out the board AGAIN and I just can't face asking Roy to fix it again. It was my own stupid fault "tinkering" when I should have just said "right, that's the controller finished". What I was thinking of doing was just getting an opto-isolated BOB which can use pins 2-9 as inputs as that would be what I really wanted and DIYCNC don't do them or I would be buying one from Roy ASAP.

If you've seen my other post this morning about the U-HID interface, well that would mean I don't actually need another BOB at all and that might be the way I go now.

Don't think you will go wrong with DIYCNC, they are very well made boards.

Regards, Jeff.