Threaded View
-
23-12-2022 #1
Timed the drop of the clamp, over a minute & also over an hour, etc on both machines (clamp dropped from 100.6 to 96.5 in period of 1 minute, mold fully closed in 46.5 minutes). 1.Replaced brake valve (issue still the same). 2.Checked oil level. Replaced oil and oil filter (issue still the same).3. Re- adjusted pressure on brake valve from 20 bar to 25 bar (no change, issue still the same). Any suggestions what could possibly be wrong?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Very mysterious dropping steps on one Y axis motor...I'm starting to lose it!!
By Hatchett Job in forum General DiscussionReplies: 25Last Post: 01-04-2022, 08:13 AM -
Herbert 2D 6 turret lathe with pegboard control and hydraulics
By JaviPK7 in forum Lathes, Lathe Rebuilding & ConversionsReplies: 3Last Post: 07-01-2022, 11:58 AM -
Triac VMC Servo // Z-Axis Dropping on power off
By danielbriggs in forum Machine DiscussionReplies: 6Last Post: 09-07-2018, 10:35 PM -
Why does it happen when you are under pressure ?
By cropwell in forum Milling Machines, Builds & ConversionsReplies: 8Last Post: 23-12-2013, 11:12 PM -
Mold Making?
By Shinobiwan in forum Moulding MachinesReplies: 10Last Post: 27-02-2013, 02:15 AM
Bookmarks