AXYZ RS485 wiring.

[maticoral]

I don't think I ever received your email in a DM.
Hit me up if you still want it and I'll share the Dropbox folder with you.
K

Hello good. I would be having the same problem as JGC ARG. I lost the toolpath software for Windows 95/98 version 2.6. Is it possible to share the dropbox with me too?
I leave you my emails [email protected] // [email protected]
Thank you

[Jgc Arg]

Mi mail es [email protected] soy de argentina, de dónde eres tú?

Translation - Lee
My email is [email protected] I'm from Argentina, where are you from?

[Jgc Arg]

I don't think I ever received your email in a DM.
Hit me up if you still want it and I'll share the Dropbox folder with you.
K

Gracias por responder. Mi correo es [email protected] soy de argentina, de dónde eres tú?

[Killiwatt]

Hey Ken.

Thanks for this very in-depth response! I appreciate it a lot. Very familiar with the toolpath workflow and had a similar way of getting paths to the machine.

Our AXYZ 4008 was setup only with the Toolpath software (had heard of DNC but didn’t bother diving deeper once we found a workflow using Toolpath)

Since I last posted this I actually went ahead and swapped out our AMC control board for a Centroid Acorn unit. - a process I intend to detail more fully over on the Centroid forum. (Tho if anyone here wants some advice pls feel free to contact me here).

I would, however, still love to see what you’ve got in this zip folder. I’m curious to see if I can get the existing Z-mouse and limit switches to communicate properly with the Acorn. I’m also curious - just for the sake of it - to see where I may have gone wrong trying to wire in a the aftermarket 485-232 adapter I bought.

I’ll send you a DM with my email.

Thanks again!

- j

Peachy, did you swap out your motor drivers as well? I'm in need of an AXI 2200 if you know of one.
Tell me more about your Centroid swap. How'd that work out?
K