Hybrid View
-
26-01-2023 #1
Did you manage to work out the wiring for the machine?
Have you got any photos of what BOB (Breakout Board) is fitted?
My suspicion is it's possibly a chargepump config issue.
The chargepump needs to receive a fixed frequency signal from the parallel port, otherwise it won't allow any of the outputs from the BOB to enable. It's a safety feature to avoid any 'random' movement/activations caused by uncontrolled parallel port outputs, which can happen as the PC hardware gets configured as the PC boots.
However, the fact the E-Stop light goes off during booting, may mean it's using a simple enable output.
Some photos of the inside of the control box would be helpful.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
-
27-01-2023 #2
Thread Information
Users Browsing this Thread
There are currently 7 users browsing this thread. (0 members and 7 guests)
Similar Threads
-
help moving mach3
By kell in forum General DiscussionReplies: 1Last Post: 07-05-2021, 03:38 PM -
moving from Mach3 to AXBB
By ngwagwa in forum CNCdrive (UC100, UC300ETH)Replies: 5Last Post: 12-04-2020, 10:01 AM -
Windows 7 ~ Microsoft relents on shorter Windows 7 support decree
By AndyGuid in forum Computer SoftwareReplies: 4Last Post: 15-08-2016, 03:30 PM -
problem unzipping a file Windows XP
By mekanik in forum General ComputingReplies: 6Last Post: 08-01-2015, 10:32 AM -
moving mach3 help please
By h4ppy-chris in forum Artsoft Mach (3 & 4)Replies: 12Last Post: 07-03-2011, 07:33 PM
Bookmarks