. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    hello please
    3 positec 5 phase mini motors and a pac controller
    3x little 5 phase motors - they dont like the mach i think as they are a 10 wire motor
    about 45mm long with a 60mm bolt doofer - so not like nema 23 which is 57mm
    erm
    the controller is a three axis affair with cards that kind of plug in
    again 5 phase
    ran from a 24v psu
    thanks

    erm has a breakout board of the rs232 variety
    a power card

    50 quid the lot

    i will have another one next weekend too
    plus me thinks a 2 axis foam cutting machine, smallish

    very nice
    located in the fulham = i.e. collection only
    postage is £150

    i am cutting the cables from the motors and using the rs232 ends to my new drives and motors
    i just bought tint nema 23's 8 wire and some little drivers - why I don't know - or I know I can get it to work.

    this maybe really easy for you
    came from a high end mini mill

    ta
    Last edited by nobby; 31-01-2023 at 07:37 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. AT1 Single Phase to Three Phase Penske Spindle Woes....
    By Cozza in forum Spindles & Drive Motors
    Replies: 6
    Last Post: 14-07-2021, 10:01 PM
  2. Replies: 0
    Last Post: 10-05-2021, 05:32 PM
  3. VFD 220v single phase to 380v three phase.
    By Richard in forum General Discussion
    Replies: 28
    Last Post: 14-12-2020, 11:19 PM
  4. Positioning three phase induction motors.
    By Agathon in forum Motor Drivers & Controllers
    Replies: 2
    Last Post: 23-04-2020, 01:02 PM
  5. Panasonic 3 phase driver running on 1 phase?
    By gavztheouch in forum Motor Drivers & Controllers
    Replies: 2
    Last Post: 10-05-2012, 11:21 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •