-
29-01-2023 #1
would like dual shafts - not important
thankstroller wise
thanks
also 6mm to 6.35 blums x3 if you have them
what is everyone using for 3 axis mach 3 nowadays?
con
-
30-01-2023 #2
Not what your asking for, but have some Vexta PK566 5phase motors and a dual shaft PK564
-
30-01-2023 #3
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Tramming With Taut Wires
By Kitwn in forum Gantry/Router Machines & BuildingReplies: 11Last Post: 26-07-2020, 02:52 AM -
Where Do The Wires Go ?
By Kev2960 in forum Chinese MachinesReplies: 10Last Post: 25-02-2017, 08:49 AM -
Hovering over "Buy"... care to sanity check my thinking?!
By brumster in forum Machine DiscussionReplies: 32Last Post: 28-01-2016, 09:53 PM -
dont you just hate it when...
By mocha in forum General DiscussionReplies: 6Last Post: 15-07-2012, 12:16 AM -
voltage on motor wires
By phill05 in forum General ElectronicsReplies: 9Last Post: 11-02-2012, 03:43 PM
Bookmarks