. .
  1. #1
    So I bought Link SpeTool Tapered Ball Nose End Mill 1/4" X 3" with 0.5mm Ball Nose 4.82Deg for CNC Machine Engraving Carving because I saw some YT videos of folks doing some nice intricate hardwood carving and they have decent feedback on bastard bezos shop. I'm attempting to make some stamps I have some nice 2.5mm stamp rubber and 2 inch white oak for the base. I was wondering :
    A. anyone had experience with this type of bit on hard wood and have some clues to plunge and feed rates, they can share?
    B. Same as a but with stamp rubber ?

    :)

    Fiction is far more plausible when wrapped around a thread of truth

    Nothing great was ever achieved without enthusiasm.
    Ralph Waldo Emerson


  2. #2
    I would run that at 24.000rpm and 40ipm for starters and normally no more than 60ipm. Not that it could not run faster but that are the perfect speeds for fine engraving without any additional finishing. Simply any wood will break fine fibers if cutting faster.
    10-ipm plunge feed
    project 1 , 2, Dust Shoe ...

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. School me on the best machine for big hardwood
    By bluesking in forum Gantry/Router Machines & Building
    Replies: 23
    Last Post: 23-04-2019, 11:50 PM
  2. tooling for hardwood
    By BobE in forum Woodwork Discussion
    Replies: 2
    Last Post: 02-12-2018, 10:27 AM
  3. 3040 and Hardwood
    By scalesr1 in forum Woodwork Discussion
    Replies: 2
    Last Post: 18-01-2018, 10:00 AM
  4. Hardwood CNC from wood on a budget, Possible?
    By Hopey in forum Gantry/Router Machines & Building
    Replies: 22
    Last Post: 16-11-2014, 07:03 PM
  5. Hardwood Supliers?
    By Stickio in forum Marketplace Discussion
    Replies: 3
    Last Post: 06-01-2011, 11:21 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •