220V single phase to 380V three phase

[mekanik]

Thanks for that John, I think i might have been clutching @ straws with this it actually came with a mains plug and that's 5 pin.
I reinstated the single phase switchgear so i get my mill attachement working and the single phase switch is different from the one supplied with the new motor.
I will try and fathom out the 2 sets of windings from the switch assemby.
Thanks again John for your time and patients.
Regards
Mike

[mekanik]

Sorry about the slight delay with the winding readings, was trying to get the motor mounted yesterday and discovered a slight problem.
John
The labels on the motor leads were only to identify the connection to the switch terminals, the issue with the cable colouring is due to what appears to be some form of insulation coating that has discoloured with the passing of time.
Readings as follows.

V4 Blue to V2 White 85.4 Ohm
V4 Blue to U2 Yellow 47.0 Ohm
W2 Green to W4 Grey 85.4 Ohm
W2 Green to U4 Red 49.4 Ohm
U4 Red to U2 Yellow 85.4 Ohm
W4 Grey to V2 White 46.5 Ohm