Thanks John
If i wire it for 2800 rpm would it be possible to reduce the speed down to 1400 without it stalling, to be honest i usually only use 2800 for centre drilling small holes and any polishing.
Does the cable comming from the VFD to the motor have to be shielded as i don't want them next door complaining when i use the machine.
any recommendations for cable size.
I wasted a lot of time trying to get the motor mounted but couldn't do it without a radical re-arrangement so i removed the end covers and swapped them with the one's off the single phase motor and there's a slight mod to do but it's only a matter of some pieces of angle iron(body of the three phase motor is shorter than the single phase)
Thanks again John,
just have to hope that the motor is OK.
Kindest Regards
Mike