Threaded View
-
27-07-2023 #6
Robin, it's only a very small pancake motor from the 90s I'd guess.
It's only a 4 wire motor, and I only applied power to one pair at a time.
I'd guess torque will be measured in fractions of Ncm. It's only moving the Z-axis on a small engraver, so not that much torque should be needed.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
What current to use for MAE HY200 3424 0310 Stepper Motor?
By Mxml in forum Stepper & Servo MotorsReplies: 2Last Post: 29-06-2023, 08:38 PM -
Help - Current For Stepper Motor Driver AM882 - ProTuner
By PaulP in forum General DiscussionReplies: 21Last Post: 22-08-2022, 08:32 AM -
Low current stepper drivers with screw terminals?
By m_c in forum Stepper & Servo MotorsReplies: 4Last Post: 05-08-2018, 06:57 PM -
Current favourite stepper drivers
By GND in forum Motor Drivers & ControllersReplies: 8Last Post: 05-03-2017, 11:52 AM -
Calculating Stepper Motor Power? Strength?
By antsals in forum General DiscussionReplies: 2Last Post: 11-07-2011, 12:18 PM
Bookmarks