Thread: Triac Z height issues
Hybrid View
-
30-11-2023 #1
Not that original then.
What stepper drivers are fitted?
A photo of the control cabinet would probably be good.
My thoughts to it having only recently started, is probably something starting to fail.
Probably worth a run around the control cabinet, making sure all screw terminals are tight, and unplugging and reseating any pluggable connectors, just to make sure there's no corrosion in any of them.
Then I'd probably be looking at the spindle motor, and the controller.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
-
30-11-2023 #2
well nearly original ;)
original stepper drivers.
cant get a photo till im back in workshop tomorrow now, its a bit messy inside be warned.
ill check all connections tomorrow
i did send the spindle motor away a number of years ago to be tested and reconditioned, set me back £500
Thread Information
Users Browsing this Thread
There are currently 9 users browsing this thread. (0 members and 9 guests)
Similar Threads
-
Gantry to bed height.
By m.i.k.e in forum Gantry/Router Machines & BuildingReplies: 20Last Post: 05-07-2020, 05:46 PM -
Tool height sensor.
By Ollie78 in forum General DiscussionReplies: 10Last Post: 27-06-2019, 09:32 PM -
Z axis height setter
By phill05 in forum General DiscussionReplies: 7Last Post: 29-11-2016, 01:14 PM -
Z Height - Max?
By Chaz in forum Gantry/Router Machines & BuildingReplies: 6Last Post: 04-02-2016, 11:18 AM -
Height Mapping?
By Tenson in forum General DiscussionReplies: 3Last Post: 26-10-2012, 11:40 PM
Bookmarks