Thread: Low torque steppers Nema 14
Threaded View
-
11-12-2023 #1
I have a non manufacture project I need a stepper for but it's low torque
I'm just rotating a Lazy Susan but I need positional accuracy which I will use a opto sensor for so I have a home
I need to extend the cabling to maybe 2m, Pi forums they said not possible due to interference
I laughed
Just solder CY 4 pin cable and earth the shielding right?
0.5mm should be fine there's very little currenthttp://www.mycncuk.com/threads/10880...60cm-work-area My first CNC build WIP 120cm*80cm
If you didn't buy it from China the company you bought it from did ;)
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Chinese 'Hybrid Closed Loop' steppers vs 'regular' open loop steppers
By clutchslip in forum General DiscussionReplies: 12Last Post: 12-11-2020, 09:23 PM -
Torque settings for HSMAdvisor
By Kitwn in forum CAD & CAM SoftwareReplies: 14Last Post: 03-07-2020, 12:27 PM -
Advice on these steppers -Nema 24 Stepper Motor 24HS34-3008D
By CharlieRam in forum Stepper & Servo MotorsReplies: 21Last Post: 19-03-2019, 08:40 PM -
WANTED: 2 nema 23's 76mm long dual shafts 6.35mm plus one 56mm long nema 23 dual shafgt 6.35
By nobby in forum Items WantedReplies: 0Last Post: 24-09-2014, 09:57 AM -
Torque Values?
By pjl83 in forum Gantry/Router Machines & BuildingReplies: 6Last Post: 04-06-2010, 10:05 PM
Bookmarks