Hi everyone, been a while since I’ve been on here, hope you guys are all good 👍🏼

I’m dealing with an issue that I’m hoping you guys can help me out with, and that is, my VFD setting have all changed/reset their self for what ever reason. I did have a power surge last week so it could be that, protection has been put in place now as it also blew one of my drives.

I’m looking for help on setting up the VFD setting again, what to input as I’ve no idea 😔 manufacturer wouldn’t help either

My setup is as follows
* VFD
Sunfar E380 3 phase,
TYPE - E380-4T0055G/0075P
SOURCE - 3PH 380V 50/60Hz
OUTPUT - 8.6KVA 13A/11KVA 17A
SERIAL NO - A00 6AHXPJFAJ0170
* Spindle
Water cooled 4.5kw
3 phase
24000 rpm
300-400Hz

VFD Manual https://salecnc.com/manuals/Inverter...s%20Manual.pdf

As always the help would be very much appreciated