Thread: Stepper motor replacement ?
Hybrid View
-
18-12-2023 #1
You'll only get that torque if you run at the full current.
The lower inductance allows faster current changes, which ultimately results in better performance.
Unless your machine is pushing the motor and driver to their performance limit, the other motor will probably fine.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
-
The Following User Says Thank You to m_c For This Useful Post:
-
31-12-2023 #2
Hello,
Thanks for the advice ,I have had another idea how about I go to a nema24 the hole centres are no problem to fix .Stepper motors online have one nema24. 4.2Nm. 4.2A. 3.3 Mh 4 wire bi polar would this be a suitable replacement ? .Thanks again look forward to hearing from you .kind regards Phil
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Options for replacement lathe spindle motor
By Doddy in forum Spindles & Drive MotorsReplies: 13Last Post: 16-05-2021, 07:47 AM -
Searching for a replacement for stepper motor driver
By Musi in forum Motor Drivers & ControllersReplies: 1Last Post: 22-10-2020, 11:20 PM -
Servo as a spindle motor replacement - what to look out for?
By Doddy in forum Stepper & Servo MotorsReplies: 23Last Post: 05-10-2020, 10:34 PM -
Myford Ml7R motor capacitor replacement
By RobC in forum Lathes, Lathe Rebuilding & ConversionsReplies: 1Last Post: 30-06-2019, 10:34 AM -
Replacement Stepfour stepper motor
By Ross Shellard in forum Stepper & Servo MotorsReplies: 3Last Post: 15-06-2016, 04:58 PM
Bookmarks