Maximat V10P runs out

[Africanimp]

Thanks, that is a very good video!

However my situation is that the headstock is not true to the beds, its pointing out towards the tailstock.

Anyway, bit by bit and with advice from forum users I am making improvments, today I removed the twist from the tailstock end, it was low at the back by over 4mm!

[mekanik]

is there any clearance between the interface on the v section ie between hedstock and bed, can you get a shim between the bed and the headstock V section. do those two small screws allow you to move the headstock ?

[Africanimp]

If the base of the headstock was shimmed up I think some sideways wiggle will be possible?

Right now I am still hoping for a forum member who had the same problem and found out how to fix it?

The Maximat VP11 had paper shims.

[mekanik]

Try asking here
https://groups.io/g/emcoV10lathe