Maximat V10P runs out

[mekanik]

is there any clearance between the interface on the v section ie between hedstock and bed, can you get a shim between the bed and the headstock V section. do those two small screws allow you to move the headstock ?

[Africanimp]

If the base of the headstock was shimmed up I think some sideways wiggle will be possible?

Right now I am still hoping for a forum member who had the same problem and found out how to fix it?

The Maximat VP11 had paper shims.

[mekanik]

Try asking here
https://groups.io/g/emcoV10lathe