Maximat V10P runs out

[mekanik]

It worked for me, try this link
[email protected]
I sent an email initially (took a while for a reply) when i was after info on my Emco 7.
then you will get access to the forum.
Here ar some more links
[email protected]
[email protected]

[Africanimp]

Thanks, I have messaged the [email protected] , when I have a reply I will post it here!

These pictures show how the gear head is fastened and located to the rails, there are no adjustments.

[mekanik]

the first of the 2 pics shows the the 2 scerews i mentioned earlier, looks like these could inpinge on the mounting screw body allowing it to have some slight allignment

[Africanimp]

They are lock screws to the threaded rod they are going into?

But why would the threaded stud have a lock screw ??

Are they there to push the gear head into line, as in the threads are say 8mm diameter in a 9.5mm diameter hole, that would give plenty of adjustment?

Its the same on the other side.

With the nuts removed and a mirror inserted underneath I may see that the stud hole is large enough to allow adjustment?

I will be checking this idea out in the morning!

[mekanik]

if it is as i thought, screws on both sides would allow you to scew the headstock. i seem to recall on some of the youtube vids that i have seen that the headstock is located on the V of the bed, there's a few video's that might be worth checking, will have a look in my manual as there is some V10 stuff there
Regards
Mike

[Africanimp]

The base plate is indeed located by the V section but the way I see it the gear head could have adjustment by screws numbered 48, I cannot find a reference to those screws, will it say lock screw or adjustment screw, this is what I need to find now?