Threaded View
-
10-01-2024 #1
I have a 10amp din rail 5v PSU I want to power a Pi 5 which wants 5amps over USB C and a few other things I want to also power, USB hub and maybe some fans but never more than 75% load
But the USB-C pinout has got me confused
Do I need to run live to all 4 power pins and gnd to all 4 ground pins to supply 5amp?
I assume this is wired in parallel right??? So they can use a smaller gauge cable
And I reading this right?
Thankshttp://www.mycncuk.com/threads/10880...60cm-work-area My first CNC build WIP 120cm*80cm
If you didn't buy it from China the company you bought it from did ;)
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: You need a CNC to make a CNC.
By quadrilateral in forum New Member IntroductionsReplies: 4Last Post: 25-04-2017, 08:13 PM -
Powering 3 45Ncm Nema 17 Stepper Motor 2A 4-wire (not CNC)
By Fivetide in forum Stepper & Servo MotorsReplies: 23Last Post: 22-11-2016, 01:32 AM -
Make your own Super- PID ... not that hard to make ! .... says electronics genius!
By Buba b in forum General ElectronicsReplies: 4Last Post: 26-04-2013, 08:37 AM -
How would you make these, or something near enough...
By irving2008 in forum General DiscussionReplies: 8Last Post: 22-09-2012, 09:36 PM -
FOR SALE: 3 x 2.5Amp 30V Stepper Drivers
By michael in forum Items For SaleReplies: 11Last Post: 13-08-2011, 02:10 PM
Bookmarks