Thread: Novamill - Mach3
Threaded View
-
29-01-2024 #4
That's a pretty generic Chinese BOB, however I'm not entirely sure of the pinouts.
I do however know the original Denford wire numbers, but they don't seem to match the hand written marks on the terminals -
57 - Home 2 (Z)
58 (assuming the 5 has fallen off) - EStop monitor signal
66
67
68 - Estop relay coil
78 - SGR (Spindle Go Relay)
66 & 67 would normally be the wiring numbers for part of the E-Stop loop (depending on the spec, the EStop loop can go through EStop button(s), limit switches, Guard interlock, and spindle motor overheat, with the wire number incrementing between each switch/sensor capable of breaking the loop).
This is the BOB, which will give you the pin mappings
Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
Thread Information
Users Browsing this Thread
There are currently 10 users browsing this thread. (0 members and 10 guests)
Similar Threads
-
FOR SALE: Denford Novamill
By Paul Urquhart in forum Items For SaleReplies: 0Last Post: 21-01-2019, 11:48 AM -
FOR SALE: Denford Novamill
By m_c in forum Items For SaleReplies: 8Last Post: 27-01-2017, 04:41 PM -
CONVERSION: Denford Novamill Mach3 conversion
By Miller in forum Conversion Build LogsReplies: 28Last Post: 25-06-2015, 04:00 PM -
FOR SALE: Novamill, converted for Mach3 for sale.
By Mad Gnome in forum Items For SaleReplies: 9Last Post: 09-10-2014, 03:23 AM -
What's best for a Novamill
By leadinglights in forum General DiscussionReplies: 6Last Post: 10-08-2010, 02:53 PM
Bookmarks