Hybrid View
-
24-03-2024 #1
I can't easily look right now but most VFDs have a 0-10V input, not +/-10V, so I'm a little surprised. It may be you can use either of those but equally, you probably can't generate that +/-10V output on your controller anyway. I was simply going on the table on one of the pages.
If I get a chance later, I will see what I can make out.
Thread Information
Users Browsing this Thread
There are currently 17 users browsing this thread. (0 members and 17 guests)
Similar Threads
-
choosing a bleed resistor
By the great waldo in forum General ElectronicsReplies: 41Last Post: 12-07-2018, 10:21 AM -
Resistor Question
By GTJim in forum General ElectronicsReplies: 1Last Post: 07-04-2013, 10:01 AM -
optoport v3 break out board wiring
By lez allen in forum Motor Drivers & ControllersReplies: 4Last Post: 26-02-2013, 07:38 PM -
Resistor Calculator
By Lee Roberts in forum General ElectronicsReplies: 2Last Post: 17-04-2012, 05:22 AM -
What type of resistor?
By Smiler in forum General ElectronicsReplies: 4Last Post: 05-12-2008, 10:04 PM
Bookmarks