Hybrid View
-
29-03-2024 #1
I am following this post with interest as i am also in the middle of an upgrade to an atc spindle which i have mounted and have running from the potentiometer , i plan on using the manual tool change butoon until i get my head around the auto tool change setup ,i also have a braking mechanism which was part of the original setup with the old spindle .i love having a go at these things myself but i am finding it difficult to get information online ,so hopefully i can get some good advice on the forum , i am running uccnc with the uc300eth-5lpt and ucbb.
Thread Information
Users Browsing this Thread
There are currently 16 users browsing this thread. (0 members and 16 guests)
Similar Threads
-
choosing a bleed resistor
By the great waldo in forum General ElectronicsReplies: 41Last Post: 12-07-2018, 10:21 AM -
Resistor Question
By GTJim in forum General ElectronicsReplies: 1Last Post: 07-04-2013, 10:01 AM -
optoport v3 break out board wiring
By lez allen in forum Motor Drivers & ControllersReplies: 4Last Post: 26-02-2013, 07:38 PM -
Resistor Calculator
By Lee Roberts in forum General ElectronicsReplies: 2Last Post: 17-04-2012, 05:22 AM -
What type of resistor?
By Smiler in forum General ElectronicsReplies: 4Last Post: 05-12-2008, 10:04 PM
Bookmarks