Testing The VFD, Break Resistor and Wiring to AXBBE

[Phil Mayor]

I set the Decel time to 3.5s

Yeah I'll have a go... so, just to be clear,

Do I set Voltmeter to DC... I know it goes in as AC but then it gets converted at some point to DC, then back again to AC, is that right..?
and just put the Red on the DC+ or R+ Terminal that the Brake Resistor is attached to and the Black to the R- Terminal that the Brake Resistor is attached too?
and take the reading as I hit stop

[marky68]

I set the Decel time to 3.5s

Yeah I'll have a go... so, just to be clear,

Do I set Voltmeter to DC... I know it goes in as AC but then it gets converted at some point to DC, then back again to AC, is that right..?
and just put the Red on the DC+ or R+ Terminal that the Brake Resistor is attached to and the Black to the R- Terminal that the Brake Resistor is attached too?
and take the reading as I hit stop

Not sure if this helps as it's a different VFD and spindle to yours but i did find out that if you don't get the parameters just right then there is no braking through the brake resistor.