Testing The VFD, Break Resistor and Wiring to AXBBE

[marky68]

Following you guys on here and this thread too, https://www.mycncuk.com/threads/1340...se-atc-spindle .

I've just started my conversion, mines a similiar spec to voyager1972. 6Kw HQD Atc spindle, ETH300 with UBB board & Uccnc controller...

Pity we're not all located close to each other..

[voyager1972]

marky68 my biggest fear was that i would make a bollocks of it ,once i got started my confidence came back and everything went ok , the only thing i need to sort now is the touchprobe as those spindle have ceramic bearings , im not sure how to get around it yet

[marky68]

marky68 my biggest fear was that i would make a bollocks of it ,once i got started my confidence came back and everything went ok , the only thing i need to sort now is the touchprobe as those spindle have ceramic bearings , im not sure how to get around it yet

I know the feeling, I'm treading slowly with it.. a lot of research done so far. It seems a bit of a black art probably as every machine is different.