. .
Page 4 of 4 FirstFirst ... 234
  1. #31
    I think I'm going to try to return this VFD, I do think it's quite a good bit of kit, it's just the Chinglish that makes this a much harder job, I've spent the last 2 weeks trying to figure this out and it feels like I take one step forward and 2 steps back.after all the testing I've done, I'm confident there is some fault somewhere.

    Thanks for all the help so far, it's a shame I couldn't get it sorted but I do appreciate it


  2. The Following User Says Thank You to Phil Mayor For This Useful Post:

Page 4 of 4 FirstFirst ... 234

Thread Information

Users Browsing this Thread

There are currently 17 users browsing this thread. (0 members and 17 guests)

Similar Threads

  1. choosing a bleed resistor
    By the great waldo in forum General Electronics
    Replies: 41
    Last Post: 12-07-2018, 10:21 AM
  2. Resistor Question
    By GTJim in forum General Electronics
    Replies: 1
    Last Post: 07-04-2013, 10:01 AM
  3. optoport v3 break out board wiring
    By lez allen in forum Motor Drivers & Controllers
    Replies: 4
    Last Post: 26-02-2013, 07:38 PM
  4. Resistor Calculator
    By Lee Roberts in forum General Electronics
    Replies: 2
    Last Post: 17-04-2012, 05:22 AM
  5. What type of resistor?
    By Smiler in forum General Electronics
    Replies: 4
    Last Post: 05-12-2008, 10:04 PM

Tags for this Thread


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts