. .
Page 2 of 2 FirstFirst 12
  1. #11
    Muzzer's Avatar
    Lives in Lytham St. Annes, United Kingdom. Last Activity: 2 Hours Ago Has been a member for 7-8 years. Has a total post count of 457. Received thanks 70 times, giving thanks to others 18 times.
    It says K1 and K2 are the tacho signal ie a DC voltage proportional to speed. I doubt that will be any use with modern drives.

    I have similar SEM motors on my Shizuoka mill with Centroid Acorn controller and drive them with a CNCdrive.com driver. However, these use step/dir for position control so wouldn't be much use to you https://cncdrive.com/downloads/DG4S_series_manual.pdf

    I suspect you might be better off using a modern servo drive that takes a direct (isolated) 0-10V analogue signal among other optional inputs. They can usually be configured for speed or position control. I have used Yaskawa servos previously but also Lichuan servos as suggested by Jazz, which are more cost effective.

  2. #12
    its controlled by Mach 3 via a uc400eth motion controller from memory i bought the Breakout board CP0-10V CNC 4 Axis with Charge Pump and Relay
    Product Code: CP0-10V which supplies the 0-10v
    from cnc 4 you
    ive had this machine a very long time and changed the spindle motor years ago so my memory of the original performance may be confused but i changed it for a reason even if i cant remember it .
    im 90% working with aluminium , cant afford a haas minimill ,so just trying to make the triac the best i can . if everyone else is getting on well with the 4000rpm dc motor where the torque seems to drop off rapidly from 1500rpm the issue might be with me.. as always advice/guidance is welcome

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 36 users browsing this thread. (0 members and 36 guests)

Similar Threads

  1. Electric or pneumatic Spindle for stone work ?
    By Fivetide in forum Machine Discussion
    Replies: 0
    Last Post: 23-07-2021, 01:03 PM
  2. Will this VFD work with this motor?
    By ChrisMe in forum General Electronics
    Replies: 4
    Last Post: 05-03-2021, 12:48 PM
  3. Replies: 2
    Last Post: 28-02-2021, 10:15 AM
  4. cant get spindle to work with Mach3
    By Bucks in forum Chinese Machines
    Replies: 16
    Last Post: 01-10-2017, 09:53 PM
  5. Replies: 2
    Last Post: 23-04-2014, 03:14 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •