Thread: Triac Spindle Changing
Hybrid View
-
05-05-2024 #1
I can't remember if I went 1kw or 1.25kw servo on mine.
I was always going to program the servo drive to run above the rated speed, but that's still on the roundtuit list.
My concern with going too fast with the stock setup, is the drawbar.
It's a fairly basic retention design, and I'm not sure how it would hold up to toolholders being spun at 10'000+rpm.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
Thread Information
Users Browsing this Thread
There are currently 4 users browsing this thread. (0 members and 4 guests)
Similar Threads
-
Triac Spindle control
By martin54 in forum Denford RoutersReplies: 0Last Post: 20-06-2022, 07:18 PM -
Denford Triac Spindle Issue
By GingerNinja54 in forum Denford MillsReplies: 39Last Post: 25-10-2021, 06:41 PM -
Denford Triac Spindle Issue
By GingerNinja54 in forum Denford MillsReplies: 1Last Post: 21-09-2021, 10:58 PM -
Spindle tool changing.
By D-man in forum Tool & Tooling TechnologyReplies: 12Last Post: 02-09-2014, 09:36 AM -
Denford Triac Spindle Fault
By Sam_Smith in forum Denford MillsReplies: 5Last Post: 04-05-2011, 11:07 PM
Bookmarks