I have ended up buying another HY VFD, (HY02D223B) to drive the 2.2 kw motor I am using in my router table. Have been looking at the manual and some on-line resources to work out what is the best way to set this up, to run as a standalone unit, No mach3 control. I am just wanting to be able to switch it on and control the speed of the motor.

I gone in and set up the VFD, from the manual for basic operations, speed range etc. When plugging in the motor the relay in the VFD isn’t clicking on - so nothing driving the motor. I left pd001 as 0, so I was assuming that the run/stop would control the unit.

Lots of conflicting on-line advice, suggesting moving jumpers and additional wires between the terminals on the controls connectors.

I am obviously being inept- advice/guidance appreciated.

Once I am past this hurdle, I will need some advice on how I set the unit the slowly ramp up the speed on startup, to allow the bearing lubrication to warm up. All stuff that I think is controlled by mach3 currently.