Cl57T closed loop stepper driver.

[terry1956]

Hi, I think I have tied myself in knots here. I am trying to understand how to set the encoder count for a full revolution of the motor. I have no idea how to find this information out, and the manual may as well be in Dutch. Can anyone help me out. Thanks

[Lee Roberts]

Did you manage to get this sorted Terry?

[terry1956]

Yes I did get it all up and running. Lots of problems of my own making. But all sorted now. Thank you all for taking interest and helping out.

[Davo242]

I installed 2 new drivers and motors on my gantry they are cl57t and 4.2a closed loop motors with built in encoder. When I move my y and x at the same time it stalls the y for a split second. Any ideas

Thanks

[JohnHaine]

Poer supply doesn't have enough current capability?

[Davo242]

I have 2 10a 36v power units maybe I should have 3 one to drive each motor. Would there be a spike when they first engage if 2 was running off the one power unit leading it to not get enough power causing the stall?

[JohnHaine]

That's what may be happening. Do you have one for x/y and the other for z?

[Davo242]

Yes that's the way it is at the minute. I'm running dual motors on the y there running off one power unit and x and z on the other