Threaded View
-
14-03-2025 #3
Last Activity: 23-07-2025
Hi again M_C,
I know you've helped me before with wiring, so thank you for coming back!
I've revised this a bit after looking at it again and reading your last post. Still not sure about certain ones, I've put ? next to them
With regard to the Temperature Sensor, I'm not sure there are a couple on the bearing front and back, but there doesn't seem to be a lot of info for these. Then there is the Thermal Switch, which states it needs to be connected in series to the E-Stop system.
The Sensors are both PNP Proximity, N.O. Sensors.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 40 users browsing this thread. (0 members and 40 guests)
Similar Threads
-
UC300ETH: UCBB Vs UB1 breakout board ?
By routercnc in forum CNCdrive (UC100, UC300ETH)Replies: 28Last Post: 31-08-2021, 12:38 AM -
BUILD LOG: uc300eth/ub1 wiring advice needed
By Gav74 in forum DIY Router Build LogsReplies: 3Last Post: 01-01-2020, 12:13 PM -
Uc300eth-5lpt overheating precautions
By jtar40 in forum General DiscussionReplies: 9Last Post: 01-08-2019, 02:04 PM -
UC300eth UB1 wiring help.
By Nickhofen in forum General ElectronicsReplies: 3Last Post: 05-09-2018, 09:12 PM -
FOR SALE: Uc300eth ub1
By Web Goblin in forum Items For SaleReplies: 6Last Post: 18-03-2018, 11:58 AM
Bookmarks