Wiring ATC with UC300eth 5LPT and UCBB

[Phil Mayor]

Hi again M_C,

I know you've helped me before with wiring, so thank you for coming back!

I've revised this a bit after looking at it again and reading your last post. Still not sure about certain ones, I've put ? next to them

With regard to the Temperature Sensor, I'm not sure there are a couple on the bearing front and back, but there doesn't seem to be a lot of info for these. Then there is the Thermal Switch, which states it needs to be connected in series to the E-Stop system.
The Sensors are both PNP Proximity, N.O. Sensors.