Wiring ATC with UC300eth 5LPT and UCBB

[Phil Mayor]

Hi Voyeger,

That would be great i'd love to see some pics and the fact you have a similar set-up to me is great too.

I'm not great with Macros either but I've been looking at them for a while now and have a few ideas, I just need to wire the Spindle signal side up to test them out..

I look forward to seeing your photo's, cheers

[voyager1972]

some pics of my setup , the manual button i have wired to a relay which controls a solenoid for the spindle toolchange,,, i also have it set that the relay is disabled when an m3 command is present so the tool cannot be manually ejected while running.