Wiring ATC with UC300eth 5LPT and UCBB

[voyager1972]

some pics of my setup , the manual button i have wired to a relay which controls a solenoid for the spindle toolchange,,, i also have it set that the relay is disabled when an m3 command is present so the tool cannot be manually ejected while running.

[Phil Mayor]

This is gonna be so helpful mate, thank you so much, I'm working away til Friday but I'll have propper look at this again then when I'm back.

[Phil Mayor]

So, after checking out the images in more detail, I've decided I'm going to go for it tomorrow, I'm still waiting on some Cable for the ATC signal and Power side but I can prepare the Air/Pneumatic side and the relays. So I'll keep updating this thread with my progress. Thanks again to you both for your help so far