Hello - Kerry lathe from ebay

[irving2008]

Hello, my name is Tim and I am a very amateur lathe user. Just to show how amateur I went and bought a Kerry lathe from ebay and and now discovered the cross-slide has been shortened and keeps locking up tight when I turn it.

I was wondering if anyone here had a Kerry AG model C lathe or details of a complete cross slide assembly that I could get copied.

I know its an oldie, but its fine except for that and I don't know what else to do?

Thanks

Tim

Tim, welcome

That wasn't the one on eBay about 2 or 3 months back? they dont come up very often...

[Bossco101]

Thank you for the warm welcome !

I've taken the cross slide to bits to have a look to see if there was anything jamming it. It's clean and in good order. I also had a play around with the gib adjustment thinking this might be the cause of the binding, but again no.

I've been in touch with Tony from lathes.co.uk who has been very helpful. I originally contacted him when I was looking for a lathe as I needed one with a +20mm spindle bore. My father has a hobby of restoring old satatioary engines and uses 20mm round steel bar for trolley axles. When I bought it, I quickly discovered that it hadn't been used for screw cutting for a while. I worked out what bits went where, and discovered one of the tumbler reverse gears had been smashed. Tony produced a new one and also provided me with a copy of the original Kerry lathe manual.

The cross slide has been a bit slower to reveal itself as a problem. I don't use the lathe very often so it wasn't till after having had it a few months that it showed up. Having had the manual from Tony I can now see from the pictures that the cross slide handle is wrong. Also now I've taken it to bits I can see where its been cut off with a hacksaw at some point.

Its been mucked about with and I need a pattern or an engineers drawing so Tony will be able to make a proper replacement. Its a real shame because its a great machine, well I think so anyway.

Yes I did buy it off ebay but about 6 months ago now. I saw the other one that was for sale too. I think a farmer had it for sale.

If I can't get this sorted I'm not really sure what to do with it. I bought it as a working machine, which currently it isn't. And who would want a non working lathe?

I hope the pictures below are of some use.

Thanks

Tim