Hello again,
I have my ATC manual Tool Change Push Button from my Spindle connected to my UCBB Inputs, none of the Input LED's are on until I press the Spindle Button, then the LED on the UCBB lights up (see image, of wiring and LED lit) it stays on until I release it, which I think is how it should work...? What I don't understand is how to get the Solenoid to activate, I have two relays wired in to my Outputs with Solenoids attached to them and I have these working with a Test Macro but how do the Inputs communicate with the Outputs, is there something I need to configure or is it a physical wire from the input to the Relay or something...?

ATC Push Button.pdf

Cheers,


Phil