ATC Pneumatics

[Phil Mayor]

Hi, again, I'm getting very close to actually running this machine now, done a lot of testing and so far so good, I'm getting closer to the end. I'm not 100 percent sure about the Pneumatic schematic drawing that comes with my ATC Spindle it suggests using a "pair of Mono-Stable Solenoid Valves in series," but I'm not sure what these are...?

I asume I can't just use a 5/2 Solenoid, I have a few spare ones ready to use??

I've attached the Schematic here.

Also what is the reason for using two Valves...?

Cheers,


Phil