Quote Originally Posted by Muzzer View Post
[*]Mounting the torch on the quill would allow vertical movement of the torch but how to avoid the thing turning? I could clamp to the outside of the quill but would need to move the home switch to prevent it trying to fully retract. That might be the way to go.[*][/LIST]

Any thoughts or previous experience I can learn from?
Not teaching you to suck eggs but have thought about the cutting speed of the plasma as they are quite high and need about 40psi gas/air ie. 3mm sheet around 5mtrs/min.

Also a torch height controller would be an advantage this is to be able to keep the torch height above the material.

Looking forward to the project.