Thread: parallel port address
Threaded View
-
06-01-2010 #1
Hello, i'm trying to set mach3 up.
i don't think i'm getting any step signals from my computer to my driver board so i thought it may be to do with my parallel port being a pci card
in config>ports and pins ,port1# port address is written 0x378 but when i look for the address of my port, by going (control panel>devise manager>pci epc parallel port(LPT3)>recources>recource type>I-O =DE00-DE07)
but whenever i type DE00-DE07 into the port address box and click o.k i just get an annoying beep and this writen in the mach3 error box 'reconfigueration estop'
anyone got any ideas???
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
USB TO Parallel Port DIY Interface
By Lee Roberts in forum Electronic Project BuildingReplies: 42Last Post: 17-02-2018, 07:46 PM -
What is the function of a parallel port breakout board?
By hbx in forum Machine Control SoftwareReplies: 13Last Post: 12-03-2013, 06:18 PM -
Stepper motor drive using mach3 from parallel port
By hmarwat370 in forum General ElectronicsReplies: 0Last Post: 04-02-2013, 08:55 AM -
Laptop, ie no parallel port?
By tompsky in forum Laptops & TabletsReplies: 3Last Post: 11-11-2008, 07:12 PM -
Which USB parallel port emulator is the best
By bruce_miranda in forum General ElectronicsReplies: 1Last Post: 18-09-2008, 03:38 PM
Bookmarks