Hello

Maybe a track ; With Fusion and Milling GCode, Fusion always write a G28 at the beginning of the code ; I don't know if it is also the case with turning Gcode, but if it is the case, you can remove the G28 to do a test. Note that the G28 return position is defined in Config/Homing limits menu.

If removing the G28 in the Gcode do the trick, you can permanently remove it by editing the post processor and change the "safe retract" value.

Have a look on the picture on this subject.

http://www.metabricoleur.com/t20125-...e-gcode#398279

++
David