Help needed proofing newbie control schematic.

[AndyUK]

Yeah, you're right I didn't read it correctly. Ignore my comments about the SSR.

This is my circuit diagram:

https://www.mycncuk.com/attachment.p...2&d=1704021402

Makerbase MKS DLC32 MAX CNC Router Board:
https://a.aliexpress.com/_EusgSEY

You wouldn't even need to write any code to get this working.

[The Gresley Luthier]

Hi AndyUK.

Wow, just looking at your schematic, that must be one big machine, the schematic is way above my skill set unfortunately, I will try to gat my head around it, but don't forget i am a novice.

I understand machines, I am a time served Tool & Die maker, but that was 55 years ago now. I am probably, on a scale of 1 - 10 a 5 when it comes to electrics/electronics.

Regards.

Ray

[The Gresley Luthier]

Hi again AndyUK.

I have spent all afternoon going through your recommendations and schematic. I must admit, I like the idea of a standalone controller, it means I will not need to use my laptop directly. There appears a lot of equipment on your schematic, I will not be needing. If you can remember my first topic I need the controller, 3 NEMA 23 Stepper motors & 3 Stepper drivers, PSU + E Stop, my router is 240 vac.

Will my chosen Motors and Drivers work on this controller, my gut say's yes, but my brains not so sure.