Help needed proofing newbie control schematic.

[AndyUK]

Yeah, you're right I didn't read it correctly. Ignore my comments about the SSR.

This is my circuit diagram:

https://www.mycncuk.com/attachment.p...2&d=1704021402

Makerbase MKS DLC32 MAX CNC Router Board:
https://a.aliexpress.com/_EusgSEY

You wouldn't even need to write any code to get this working.

[The Gresley Luthier]

Hi AndyUK.

Wow, just looking at your schematic, that must be one big machine, the schematic is way above my skill set unfortunately, I will try to gat my head around it, but don't forget i am a novice.

I understand machines, I am a time served Tool & Die maker, but that was 55 years ago now. I am probably, on a scale of 1 - 10 a 5 when it comes to electrics/electronics.

Regards.

Ray

[The Gresley Luthier]

Hi again AndyUK.

I have spent all afternoon going through your recommendations and schematic. I must admit, I like the idea of a standalone controller, it means I will not need to use my laptop directly. There appears a lot of equipment on your schematic, I will not be needing. If you can remember my first topic I need the controller, 3 NEMA 23 Stepper motors & 3 Stepper drivers, PSU + E Stop, my router is 240 vac.

Will my chosen Motors and Drivers work on this controller, my gut say's yes, but my brains not so sure.

[EddyCurrent]

Ray,

Taking into consideration all of your responses to all of the threads you have posted, my conclusion is this;

You want to make guitars so just buy a cnc machine that is already built, be it new or second hand,.
It's going to be easier, faster, maybe even cheaper,I know this because of my own cnc journey,

Thanks to this forum I came to understand the fundamentals of cnc machine design and then thanks to my existing electrical and mechanical knowledge the build was quite easy.