New Member, a little experience with 'toy CNC' but got a bigger baby now :-) !!

[SteveNotlob]

Hello m_c,
Thanks for the input.
The machine owes me £200 already (£159 to buy it and around £40 in fuel to collect it) so I am thinking of taking the gamble with using these parts if I can.
The drivers do have the pinouts printed on the connector so that is not a problem.
I was hoping for some input from Infotec regarding the software but if I don't hear anything in the next week then I will go ahead with the Mach3 conversion. I know Mach3 may not be the best or newest out there but as you correctly pointed out, I do have some experience with it. Hopefully all will be OK ! :-)
Yesterday I spent an hour, and a can of WD40, getting to every nut, bolt, screw, mechanical bits that I could. Weather permitting I am hoping to get to the screwy,rolly,motory bits today and tomorrow to give them a good clean... Sorry about trerminology but I really don't have a clue on technical terms...
Anyway, I think I should start another post in relevant forum for any other help rather than continuing in the Newbie 'Hello World' one.

Regards, Stephen