Spindle to VFD cable...

[ZeroReciprocity]

What are people using for cable to connect from the VFD to the Spindle?

I know they recommend shielded/screened cable but I've also read in some places that it should be double shielded/screened. I've also read that you need to ensure that the cable has been designed to support continuous flexing.

Is 1.5mm2 CY cable ok to use? Can it stand the constant flexing that it will be subject to, and will its single shielding/screening be enough.

Cheers

[Muzzer]

1.5mm CY (screened flexi cable) should be fine for up to 16-18A. Good to see you using screened cable - and there's really no need for two braids.

There's a lot of bollards talked about when it comes to how to connect the screen - one end or both. Neither is right or wrong but I usually ground both ends, as recommended by Yaskawa. Others recommend just one end, although even then they may differ which one.....

Moving on from that old chestnut, it's also important to fit an EMC filter on the mains side of your VFD. Most of the Chinese ones don't come with one and many DIY projects get in trouble with the resulting electrical noise. The benchmark brands would be something like Schaffner or TDK/EPCOS, which you can assume will actually achieve some degree of filtering. God alone knows what if anything you might find inside an Aliexpress special.