Work scrap bin router build

**Vic66** · 14-01-2010

Hi Tim

The Joe's Hybrid machine seems to have quite a following with the V bearings (smaller than the ones I have) setup the same as my model, have you got a link to how it's done on the Mechmate ?

Vic

**Wobblybootie** · 14-01-2010

Vic,

http://www.mechmate.com If you sign up to the forum (no charge) you have full access to all the drawings for a machine ... the Forums are a wealth of information but only about these machines ... There is a massive section on the pros and cons of V wheels and masses of info on grinding the angle iron ...

If I had the space for one of these, I would build it without hesitation. For a machine that can run all day machining 1" MDF with a huge router some of the stuff produced is stunning some very good fine detail 2.5D work etc.

**Vic66** · 14-01-2010

Thanks Tim, I have seen that before but did'nt notice they were using V bearings, have registered will browse around later.

Like the Eddy avatar by the way !

Vic