Quote Originally Posted by HS93 View Post
I am new so may be talking rubbish , but can you not test the setup when finnished by placing a cheap DTI on the motor head touching the bed and then send the head around the table to see if it is the same all over ?
Hi Peter

Unfortunately the bed and gantry can be far from flat, but, having the same distortion, line up perfectly with regard to tool height.

This may be fine and dandy, only becoming a problem when the thing you want to cut doesn't want to conform as well. Or worse, starts out by comforming then changes it's mind when you start to cut it smaller.

I still like my idea of gluing a laser pen to a lump then moving it around watching where it hits on the wall. It's simple, cheap, amazingly accurate and would save all this faffing about

Robin