Thread: Trend T4 Router
-
01-02-2010 #1
Hi all
A couple of months ago I purchased a Trend T4 850 Watt Router, unfortunately i seem to have wrecked the lower bearing - Has anyone anyone got any experience of replacing the bearings on these? - I have removed the bearing lock plate and the collar and I can see the bearings, but I just cannot free it from the spindle.Last edited by petejw; 01-02-2010 at 11:49 PM.
-
02-02-2010 #2
Hi Pete
I havent got one but just looked at the trend side and found this if it helps. Looks like there is a separate roller and thrust bearing. so maybe the top needs to come off as well and withdraw the main shaft upwards.
-
02-02-2010 #3
Hi,
I think you will need to take the top off as well, i had to to this for mine. Mine isnt a Trend but its very much the same.
Lee.Me
-
14-02-2010 #4
Thanks for the help guys, finally managed to get the bearing out and new one installed. All it needed in the end was a good sharp tap with a mallet
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Trend CNC Mini
By longy in forum Machine DiscussionReplies: 5Last Post: 09-05-2014, 04:06 PM -
Best all round mill/router? Vertical mill or gantry router?
By Richard in forum Machine DiscussionReplies: 2Last Post: 18-02-2014, 04:18 PM -
Kress v trend
By motoxy in forum Spindles & Drive MotorsReplies: 16Last Post: 03-01-2012, 11:08 PM
Bookmarks