. .

Thread: Trend T4 Router

  1. #1
    Hi all
    A couple of months ago I purchased a Trend T4 850 Watt Router, unfortunately i seem to have wrecked the lower bearing - Has anyone anyone got any experience of replacing the bearings on these? - I have removed the bearing lock plate and the collar and I can see the bearings, but I just cannot free it from the spindle.
    Last edited by petejw; 01-02-2010 at 11:49 PM.

  2. #2
    Hi Pete
    I havent got one but just looked at the trend side and found this if it helps. Looks like there is a separate roller and thrust bearing. so maybe the top needs to come off as well and withdraw the main shaft upwards.
    Attached Thumbnails Attached Thumbnails spare_dia_t4.pdf  

  3. #3
    Hi,

    I think you will need to take the top off as well, i had to to this for mine. Mine isnt a Trend but its very much the same.

    Lee
    .Me

  4. #4
    Thanks for the help guys, finally managed to get the bearing out and new one installed. All it needed in the end was a good sharp tap with a mallet

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Trend CNC Mini
    By longy in forum Machine Discussion
    Replies: 5
    Last Post: 09-05-2014, 04:06 PM
  2. Best all round mill/router? Vertical mill or gantry router?
    By Richard in forum Machine Discussion
    Replies: 2
    Last Post: 18-02-2014, 04:18 PM
  3. Kress v trend
    By motoxy in forum Spindles & Drive Motors
    Replies: 16
    Last Post: 03-01-2012, 11:08 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •